Victorio VKP1024 Instruction Manual download pdf (Page 19)

MOTOR TROUBLESHOOTING GUIDE

PROBLEM SOLUTION

I cannot attach the motor. Review p. 14 on how to attach the

motor, including how to correctly

align the motor shaft with the grain

mill shaft.

I cannot remove the motor. Sometimes the motor shaft can

get stuck or be difcult to remove.

Read all the Removal Steps on p.

15.

The motor is working but no grain

is going through the mill.

Sometimes grain can get stuck

and will not ow into the grinding

chamber. Gently tap the side

of the grain mill, just below the

hopper, using the side of your st

or heel of your hand. This will

loosen the grains and help them

ow into the grinding chamber.

Grain is going through, but the

grain mill is producing very little or

no our.

Carefully follow the Use

Instructions on p. 7 and make

certain, after you tighten the

adjustment knob, you turn it

back at least 1/4 turn. An overly-

tightened adjustment knob can

damage the milling cone, especially

while using the motor.

The motor does not turn on. Review the instructions and

diagram on p. 13 about the Power

Switch and the Overload Breaker.

The motor does not turn on and

the overload switch is not tripped.

Make sure the cord is plugged into

a live power outlet. Review the

diagram on p. 13 about the Power

Switch. Make sure the switch on

your motor matches the diagram

for the on, (“I”) position.

1 2 ... 14 15 16 17 18 19 20

No comments

Victorio VKP1024 Instruction Manual Page 19